Rockwell-automation 1394C-SJT_CONN-KEY Installing Your Power Connector Manual de usuario descargar pdf (Pagina 5)

Installing Your 1394C Power Connector Key Kit 5

Publication 1394-IN023A-EN-P — July 2000

Replacing the Shunt Power Connector Plug

To replace the shunt power connector plug:

2. Remove jumper from the replacement connector plug (supplied

in the kit) and insert the wires as shown in the table below.

3. Gently pull on each wire (or jumper) and make sure it does not

come out of its terminal(s). Re-insert and tighten any loose wires.

Inserting Keys into the System Module Connectors

1. Insert a key into the beveled slot above the input power connector

terminal on the far right. This terminal lines up with the connector

plug terminal labeled PE (refer to Figure 3 for key placement).

2. Insert a key into the beveled slot above the shunt power connector

terminal on the far left. This terminal lines up with the connector

plug terminal labeled COL (refer to Figure 3 for key placement).

If the 1394-SR10A

shunt resistor is:

Then:

Installed

1. Loosen the screws in the old shunt

power connector plug and remove

the wires from each terminal

(refer to Figure 2 for connector

location).

2. Go to main step 2.

Not installed Go to main step 3.

Insert the wires

labeled:

Into the connector

plug terminals labeled:

Tighten to this

torque value:

COL COL

0.56-0.62 N-m

(5.0-5.6 lb-in.)

DC+ DC+

1 2 3 4 5 6 7 8

Sin comentarios

Rockwell-automation 1394C-SJT_CONN-KEY Installing Your Power Connector Manual de usuario Pagina 5