Rockwell-automation 1732E-XXXX ArmorBlock 2-Port EtherNet/IP Modules w Manual de usuario descargar pdf (Pagina 6)

6 1732E ArmorBlock 2-Port EtherNet/IP Modules with QuickConnect

Publication 1732E-IN010C-EN-E - June 2013

Install the Module

To install the module:

• Set the network address

•Mount the module

• Connect the I/O, Network and Auxiliary cables to the module.

Set the Network Address

The I/O block ships with the rotary switches set to 999 and DHCP enabled.

To change the network address, you can do one of the following:

• adjust the switch on the front of the module.

• use a Dynamic Host Configuration Protocol (DHCP) server, such as Rockwell

Automation BootP/DHCP.

• retrieve the IP address from nonvolatile memory.

The I/O block reads the switches first to determine if the switches are set to a valid

number. To set the network address:

1. Rotate the three (3) switches on the front of the module using a small

blade screwdriver.

2. Line up the small notch on the switch with the number setting you wish to use.

Valid settings range from 001…254.

3. Cycle power.

1732E-16CFGM12P5QCR 16 channel 24V DC self-configurable digital

I/O dual-port Ethernet module with

QuickConnect

Dual D-code

M12

Dual 5-pin

mini

1732E-16CFGM12QCWR 16 channel 24V DC self-configurable digital

I/O dual-port Ethernet metal WeldBlock

module with QuickConnect

Dual D-code

M12

Dual 4-pin

mini

1732E-16CFGM12P5QCWR 16 channel 24V DC self-configurable digital

I/O dual-port Ethernet metal WeldBlock

module with QuickConnect

Dual D-code

M12

Dual 5-pin

mini

Catalog Number Description Network

Connector

Auxiliary

Power

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comentarios a estos manuales

Sin comentarios