Rockwell-automation 1762-OB16 Solid State 24V dc Source Output Module Manual de usuario descargar pdf (Pagina 9)

Solid State 24V DC Source Output Module 9

Publication 1762-IN011B-EN-P - June 2013

Wiring the Finger-Safe Terminal Block

When wiring the terminal block, keep the finger-safe cover in place.

1. Route the wire under the terminal pressure plate. You can use the stripped end of the wire or a

spade lug. The terminals will accept a 6.35 mm (0.25 in.) spade lug.

2. Tighten the terminal screw making sure the pressure plate secures the wire. Recommended

torque when tightening terminal screws is 0.90 Nm

(8 lb-in.).

ATTENTION

Miswiring of the module to an AC power source will damage the module.

TIP

Finger-safe cover not shown for clarity.

TIP

If you need to remove the finger-safe cover, insert a screw driver into one of

the square wiring holes and gently pry the cover off. If you wire the

terminal block with the finger-safe cover removed, you will not be able to

put it back on the terminal block because the wires will be in the way.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Rockwell-automation 1762-OB16 Solid State 24V dc Source Output Module Manual de usuario Pagina 9