Rockwell-automation 1769-OF2 Compact (Series B or Later) Analog Output Manual de usuario descargar pdf (Pagina 12)

12 Compact™ 1769-OF2 (Series B or Later) Analog Output Module

Publication 1769-IN049A-EN-P

Wiring the Finger-Safe Terminal Block

When wiring the terminal block, keep the finger-safe cover in place.

1. Loosen the terminal screws to be wired.

2. Route the wire under the terminal pressure plate. You can use the bare

wire or a spade lug. The terminals will accept a 6.35 mm (0.25 in.) spade

lug.

3. Tighten the terminal screw making sure the pressure plate secures the

wire. Recommended torque when tightening terminal screws is 0.68 Nm

(6 in-lbs).

NOTE

The terminal screws are non-captive. Therefore, it is

possible to use a ring lug [maximum 1/4 inch o.d. with a

0.139 inch minimum i.d. (M3.5)] with the module.

NOTE

If you need to remove the finger-safe cover, insert a screw

driver into one of the square, wiring holes and gently pry

the cover off. If you wire the terminal block with the

finger-safe cover removed, you will not be able to put it

back on the terminal block because the wires will be in the

way.

wiring the

finger-safe

terminal block

upper retaining screw

lower retaining screw

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sin comentarios

Rockwell-automation 1769-OF2 Compact (Series B or Later) Analog Output Manual de usuario Pagina 12