Rockwell-automation 1771-OC DC Output Driver Module Installation Instr Manual de usuario descargar pdf (Pagina 10)

DC Output Driver Module10

    

Each module output is individually fused. You can easily access the

module fuses by removing the front component–side cover.



Remove power from the 1771 I/O chassis

backplane and wiring arm before removing or

installing the module.

• Failure to remove power from the backplane or

field wiring arm could cause module damage,

degradation of performance, or injury.

• Failure to remove power from the backplane

could cause injury or equipment damage due to

possible unexpected operation.

If a blown fuse occurs:

1. Turn off power to the I/O chassis backplane.

2. Pivot the wiring arm away from the module and pull the module

from the I/O chassis.

3. Remove the front half of the protective cover from the unlabeled

side of the module by removing the two slotted screws.

4. Replace the blown fuse with a 2A, 250V 8AG normal blow fuse.

5. Replace the protective cover and install the module in the I/O

chassis.

6. Reposition the wiring arm.

7. Restart system power.

  

1 2 ... 5 6 7 8 9 10 11 12

Sin comentarios

Rockwell-automation 1771-OC DC Output Driver Module Installation Instr Manual de usuario Pagina 10