Rockwell-automation 1784-PCIDS DeviceNet PCI Communication Interface C Manual de usuario descargar pdf (Pagina 46)

6-2 Use the DeviceNet Test Application to Verify the Configuration

Publication 1784-IN004E-EN-P - April 2005

Start the Test Application

The test application is automatically installed as part of the driver installation procedure.

To start the test application, click Start ⇒Programs ⇒Rockwell Software ⇒IOLinx

⇒

IOLinx for DeviceNet ⇒DeviceNet Test.

If the driver cannot establish communication with the module, an error message is displayed.

Configure the Port

You must configure the port the first time you use a 1784-PCIDS card.

To configure the port, follow these steps:

1. Select Configure Port... from the Setup menu.

2. Select Allen-Bradley 1784-PCIDS from the DeviceNet Driver Selection screen.

3. Click on Select.

4. Set Node Address (0 - 63).

5. Set Baud Rate (125/250/500 kbs).

6. Click OK. You see a dialog box that tells you operation was successful, followed by a

similar message box that tells you that the port has been configured.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 67 68

Sin comentarios

Rockwell-automation 1784-PCIDS DeviceNet PCI Communication Interface C Manual de usuario Pagina 46