Rockwell-automation 1794-ASB Remote Flex I/O Adapter Installation Inst Manual de usuario descargar pdf (Pagina 3)

FLEX I/O Remote I/O Adapter 3















1. Position the remote I/O adapter module A on a 35 x 7.5mm DIN rail

B (A-B pt. no. 199-DR1; 46277-3; EN 50022) at a slight angle.

2. Hook the lip on the rear of the adapter (A) onto the top of the DIN rail

(B), and rotate the adapter module onto the rail.

3. Press the adapter module down onto the DIN rail until flush. Locking

tab (C) will snap into position and lock the adapter module to the DIN

rail.

4. If the adapter module does not lock in place, use a screwdriver or

similar device to move the locking tab down while pressing the

adapter module flush onto the DIN rail and release the locking tab to

lock the adapter module in place. If necessary, push up on the locking

tab to lock.

5. Connect the adapter wiring as shown under “Wiring” later in this

document.

NOTE: For Panel/Wall mounting, refer to publication 1794-5.13, “Panel

Mounting Kit, Cat. No. 1794-NM1.”

1 2 3 4 5 6 7 8 ... 11 12

Sin comentarios

Rockwell-automation 1794-ASB Remote Flex I/O Adapter Installation Inst Manual de usuario Pagina 3