Rockwell-automation 20P, 23P PowerFlex DC Drive and SAR Control Circui Manual de usuario

Publication 20P-IN004B-EN-PPowerFlex® DC Drive and Stand-Alone Regulator (SAR)Control Circuit BoardInstallation InstructionsWhat This Kit Includes• Co

Publication 20P-IN004B-EN-P10Step 5B: Remove the Optional I/O Expansion BoardIf the optional I/O expansion board is not installed, continue with Step

11Publication 20P-IN004B-EN-P4. Remove the two stand-offs and washers that support the I/O expansion board on the control board.=Remove two stand-offs

Publication 20P-IN004B-EN-P12Step 5C: Remove the 115V AC to 24V DC Converter BoardIf the optional 115V AC to 24V DC converter board is not installed,

13Publication 20P-IN004B-EN-PStep 6: Remove the Existing Control Board1. Record the DIP switch and jumper settings on the control board.Jumper/Switch

Publication 20P-IN004B-EN-P142. Carefully disconnect the cables from connectors XFCD, XA, and XR on the control board.3. Remove the plug-in I/O and co

15Publication 20P-IN004B-EN-PStep 7: Install the New Control Board1. Install the new control board in the reverse order of removal as detailed in Step

Publication 20P-IN004B-EN-P16Step 9: Document the Change1. Record the installation of the new control board and date of installation on the field inst

17Publication 20P-IN004B-EN-PNotes:

Publication 20P-IN004B-EN-P - June 2011Supersedes 20P-IN004A-EN-P - October 2007 Copyright © 2011 Rockwell Automation. All rights reserved. Printed in

Publication 20P-IN004B-EN-P2What You Need to DoTo install the Control board:❐ Step 1: Save the Parameter Configuration❐ Step 2: Remove Power from the

3Publication 20P-IN004B-EN-PStep 3: Remove the Drive Covers• To open frame A drives and the stand-alone regulator, see Frame A Drives and the Stand-Al

Publication 20P-IN004B-EN-P4Frame B and C Drives1. Disconnect the DPI cable from the HIM (if present).2. Loosen, but do not remove, the screws that se

5Publication 20P-IN004B-EN-PFrame D Drives1. Disconnect the DPI cable from the HIM assembly (if present).2. Loosen, but do not remove, the four hexalo

Publication 20P-IN004B-EN-P6Disconnect the HIM Communication CableFor all drives, disconnect the HIM communication cable from the connector on the upp

7Publication 20P-IN004B-EN-P3. Remove the four screws that secure the adapter to the EMI shield and remove the adapter.4. Remove the three screws that

Publication 20P-IN004B-EN-P8Step 5: Remove the Existing Connections and Option Board(s)If the optional resolver feedback module, I/O expansion, and 11

9Publication 20P-IN004B-EN-P3. Carefully lift the resolver interface module off of the control board, pulling the stacker connector out of the XRE con