Rockwell-automation 20P PowerFlex DC Drive - Frame B Field SCR Module Manual de usuario descargar pdf (Pagina 4)

4 PowerFlex® DC Drive - Frame B Field SCR Module

Step 2: Remove the

Protective Covers

1. Disconnect the DPI cable from the HIM assembly (if present).

2. Loosen, but do not remove, the screws that secure the bottom cover to

the drive, then slide the cover down and off the drive chassis.

3. Loosen, but do not remove, the screws that secure the top cover to the

drive, then slide the cover up and off the drive chassis.

Important: The HIM assembly is connected via a cable to the Control

board and therefore will not pull free from the drive until

disconnected. See step 4 below for instructions.

Disconnect

DPI cable

Tightening torque:

1.5 N•m (13.3 lb•in)

Tightening torque:

1.5 N•m (13.3 lb•in)

1 2 3 4 5 6 7 8 9 ... 13 14

Sin comentarios

Rockwell-automation 20P PowerFlex DC Drive - Frame B Field SCR Module Manual de usuario Pagina 4