Rockwell-automation 20P PowerFlex DC Drive - Frame C Switching Power S Manual de usuario descargar pdf (Pagina 7)

PowerFlex® DC Drive - Frame C Switching Power Supply Circuit Board 7

6. Remove the six screws and washers that secure the board to the Control

EMI shield and remove the board.

Important: DO NOT remove the Isolation shield below the board

unless it is damaged and you are replacing it with a new

sheet.

Step 4: Install the New

Switching Power Supply

Board

1. Install the new Switching Power Supply board in reverse order of

removal as detailed in Step 3: Remove the Switching Power Supply

Board on page 4.

2. Replace the 16 Pin cable connected to connector XA on the Switching

Power Supply board with the new cable provided.

Remove six screws and washers

Front of drive

1 2 3 4 5 6 7 8

Sin comentarios

Rockwell-automation 20P PowerFlex DC Drive - Frame C Switching Power S Manual de usuario Pagina 7