Rockwell-automation 20P PowerFlex DC Drive - Frame D Switching Power S Manual de usuario descargar pdf

Publication 20P-IN049A-EN-P

PowerFlex® DC Drive

Frame D Switching Power Supply Circuit Board

Installation Instructions

What This Kit Includes

• Switching Power Supply circuit board

• 16 Pin Ribbon cable

• Five screws with captive lock washers

• Static strap

Tools That You Need

• Phillips

screwdriver

• Hexalobular screwdriver

Phillips

is a registered trademark of Phillips Screw Company.

What You Need to Do

To install the switching power supply board:

❐ Step 1: Remove power from the drive

❐ Step 2: Remove the protective covers

❐ Step 3: Remove the existing switching power supply board

❐ Step 4: Install the new switching power supply board

❐ Step 5: Replace the protective covers and document the change

ATTENTION: Only qualified personnel familiar with DC drives

and associated machinery should plan or implement the installation,

start-up and subsequent maintenance of the system. Failure to comply

may result in personal injury and/or equipment damage.

ATTENTION: To avoid an electric shock hazard, ensure that all

power to the drive has been removed before performing the following.

ATTENTION: This drive contains ESD (Electrostatic Discharge)

sensitive parts and assemblies. Static control precautions are required

when installing, testing, servicing or repairing this assembly.

Component damage may result if ESD control procedures are not

followed. If you are not familiar with static control procedures,

reference A-B publication 8000-4.5.2, “Guarding Against

Electrostatic Damage” or any other applicable ESD protection

handbook.

1 2 3 4 5 6

Indice de contenidos

Pagina 1 - Installation Instructions

Publication 20P-IN049A-EN-PPowerFlex® DC DriveFrame D Switching Power Supply Circuit BoardInstallation InstructionsWhat This Kit Includes• Switching P

Pagina 2 - Protective Covers

Publication 20P-IN049A-EN-P2Step 1: Remove Power from the Drive1. Remove and lock-out all incoming power to the drive. Step 2: Remove the Protective C

Pagina 3 - Figure 1 Cover Removal

3Publication 20P-IN049A-EN-PFigure 1 Cover Removal 4. Disconnect the HIM communication cable from the connector on the upper right corner of the Con

Pagina 4 - Supply Board

Publication 20P-IN049A-EN-P4Step 3: Remove the Existing Switching Power Supply Board1. Loosen the eight hexalobular screws that secure the protective

Pagina 5 - Publication 20P-IN049A-EN-P

5Publication 20P-IN049A-EN-PStep 4: Install the New Switching Power Supply BoardInstall the new switching power supply board in reverse order of remov

Pagina 6

Mas documentos para Equipo Rockwell Automation 20P PowerFlex DC Drive - Frame D Switching Power S

a Ver el documento Rockwell-automation 20P PowerFlex DC Drive - Frame D Switching Power S Manual de usuario

Rockwell-automation 20P PowerFlex DC Drive - Frame D Switching Power S Manual de usuario (4 paginas)

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 20P PowerFlex DC Drive - Frame D Switching Power S Manual de usuario

Busca en linea o descarga Manual de usuario para Equipo Rockwell-automation 20P PowerFlex DC Drive - Frame D Switching Power S. Rockwell Automation 20P PowerFlex DC Drive - Frame D Switching Power Supply Circuit Board User Manual Manual de usuario

Indice de contenidos

Mas documentos para Equipo Rockwell Automation 20P PowerFlex DC Drive - Frame D Switching Power S

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 20P PowerFlex DC Drive - Frame D Switching Power S