Rockwell-automation 2364P Overhead Bus for Bulletin 2300 MCCs Manual de usuario descargar pdf

Publication 2364P-5.10 - December 1999

Installation Instructions

Overhead Bus for Bulletin 2300 MCCs

For Use in Parallel Bus Supply Configurations

Contents This document shows how to install overhead bus assemblies on to Bulletin

2300 Motor Control Centers (MCCs).

What This Kit Contains This kit contains the necessary quantities of the following parts, as needed

and called out on your Certified Cabinet Outline Drawing (often labeled as

DS-drawing number) that is shipped with your drive system schematics.

Refer to Figure 1 for part types that may be included in your kit.

Figure 1

Parts That May Be Included in Your Overhead Bus Splice Kit

Splice Assemblies

Splice-Joiner

Assembly

Feeder Splice

Assembly

End Cap

Bus Tabs

23” Bus Tab 2.5” Bus Tab 4” Bus Tab

Overhead Bus Assemblies

20” Overhead

Bus Assembly

25” Overhead

Bus Assembly

30” Overhead

Bus Assembly

35” Overhead

Bus Assembly

1 2 3 4 5 6 7 8

Indice de contenidos

Pagina 1 - Installation Instructions

Publication 2364P-5.10 - December 1999Installation InstructionsOverhead Bus for Bulletin 2300 MCCsFor Use in Parallel Bus Supply ConfigurationsContent

Pagina 2

Publication 2364P-5.10 - December 19992Other Items Needed Before you begin, be sure you have the following:• Tools you will need to:• Loosen, tighten,

Pagina 3 - Figure 2

Publication 2364P-5.10 - December 19993Preliminary Steps Before you begin the procedures in this document:1. Verify that the individual shipping split

Pagina 4 - Figure 3

Publication 2364P-5.10 - December 19994Note: Verify that there is sufficient working space above and around the MCCs. If not, install the bus tabs a

Pagina 5 - Figure 4

Publication 2364P-5.10 - December 19995Bolt Assembly½” ConicalWasher½” Flat Washer½” Nut½” Flat Washer½”-13 x 2¼”(Specifications apply to feeder and b

Pagina 6 - Figure 5

Publication 2364P-5.10 - December 199966. For each input bay that is to be supplied by the overhead bus:a. Remove the top cover and side covers of the

Pagina 7 - Figure 6

Publication 2364P-5.10 - December 199977. Mount the bus assemblies to the MCCs as shown in Figure 6 (use the taptite hardware that was previously remo

Pagina 8 - Concluding Steps