Rockwell-automation 2707-NP DTAM PLUS GETTING STARTED USER MANUAL Manual de usuario descargar pdf (Pagina 67)

A–B

Chapter

7–1

SLC Application File

This chapter provides the ladder logic program required to run the DTAM

Plus sample application.

You can program an SLC 500 using either of the following:

 Advanced Programming Software (APS) on a personal computer

 Hand-Held Terminal

This manual does not provide instructions on how to program the SLC

controller. Refer to the User Manuals for the equipment you are using.

Included in this chapter is the logic program you need to enter.

To provide values for the sample program, the data below must be loaded

into the following SLC data files.

Address 0 1 2 3 4 5 6 7 8 9

N10:0 0 30 77 122 144 179 222 245 259 278

N10:10 301 322 367 378 399 488 512 533 542 588

N10:20 601 544 566 567 533 521 524 500 433 333

N10:30 288 266 211 197 155 140 98 55 11 0

N10:40 0 3 8 12 14 18 22 25 26 28

N10:50 30 32 37 38 40 49 51 53 54 59

N10:60 60 54 57 57 53 52 52 50 43 33

N10:70 29 27 21 20 16 14 10 6 1 0

N10:80 0 0 1 1 5 5 5 5 1 5

N10:90 5 1 1 5 5 4 4 0 5 5

N10:100 4 5 0 4 5 5 5 4 0 0

N10:110 0 0 0 0 0 0 0 0 0 0

N10:120 0

Chapter Objectives

Configuring the SLC 500

Preloaded Values

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 73 74 75

Sin comentarios

Rockwell-automation 2707-NP DTAM PLUS GETTING STARTED USER MANUAL Manual de usuario Pagina 67