Rockwell-automation 2711P-RPPU PanelViewPlus Logic Module Pullup Board Manual de usuario descargar pdf (Pagina 4)

Publication 2711P-IN028A-EN-P - December 2005 PN 41061-372-01(1)

1. Disconnect power from the terminal.

2. If the Display Module is removed from the panel, set the terminal, display

side down, on a clean, flat, stable surface.

3. Remove the label covering the Communication Module connector on the

Logic Module.

4. Position the Pullup Board over the Logic Module so that the connector on

bottom of the board aligns with connector on Logic Module.

5. Press the Pullup Board firmly into place.

Allen-Bradley, PanelView Plus, VersaView and Rockwell Automation are trademarks of Rockwell Automation, Inc.

Trademarks not belonging to Rockwell Automation are the property of their respective holders.

ATTENTION Work in a static free environment and wear a properly grounded

ESD wristband. Do not touch the Communication Module

connector or its internal circuitry to avoid ESD (Electrostatic

Discharge).

Logic Module

Pullup Board

1 2 3 4

Sin comentarios

Rockwell-automation 2711P-RPPU PanelViewPlus Logic Module Pullup Board Manual de usuario Pagina 4