Rockwell-automation 45MLA Controller Installation Instructions Manual de usuario descargar pdf (Pagina 4)

Additionally, the CAN and RS485 controller models offer the

flexibility of adjusting these settings through use of specified

commands over the serial interface.

Resetting Default Parameter Settings

All controllers are shipped with default parameter values, that can

be changed through the teach process for the I/O model and

through serial commands for the RS485 and CAN models. The

default parameters can be reset in all models through the

following procedure:

• Turn controller power off.

• Set switch 8 on DIP switch array S1 to ON.

• Turn controller power on.

• Set switch eight on DIP switch array S1 to OFF.

• Default settings should now be restored.

Functional Description—Analog Model

Figure 3: Analog Model

The analog controller model offers either 4…20 mA or 0…10V

(current or voltage selectable via DIP switch) output proportional

to target height, width, or position. The output is automatically

scaled to the length of the connected arrays, so most applications

do not require additional adjustments. A teach button is available

for applications that require customized scaling of the output.

In 2

PNP

NPN

PNP

NPN

D7 LED - Power

Analog

Extension

PCB

D3 LED Out 1

D4 LED Out 2

D6 LED In 2

D5 LED In 1

D13 LED

D15 LED

D12 LED

D11 LED

D10 LED

RJ45 Connector

Emitter

RJ45 Connector

Receiver

D2 LED

D1 LED

In 1

Pot 2

Pot 1

Teach

Push-

Button

Removable

Spring-Loaded

Connector

Input

Logic

Jumpers

J15

Out 1

Out 2

In 1

In 2

n. c.

Earth.

24 VDC

0 VDC

D16 LED

Pin Listings

The allocation of pins on the main connector, J2, is specified

below.

Table 6: J2 Pin Listings

The allocation of pins on the I/O extension PCB is described

below.

Table 7: J15 Pin Listings

LED Indicators

The following table describes LED status for LEDs D15 and D16

present on the extension PCB.

Table 8: Analog Board LED Descriptions

DIP Switch Settings

DIP switches 1 through 6 on the S1 DIP switch array are

configured for the various applications described below. If no

information is otherwise provided these DIP switches should

remain in the OFF position.

DIP switch 8 is used to reset default configuration.

Pin Signal Description Remarks

10V DC Power —

2+24V DC Power —

3 Ground Ground —

4 Not connected Not connected —

5 In 2 Not used

6In 1

Not used DIP switch S1 (3) = 0

Remote teach DIP switch S1 (3) = 1

7 Out 2 Error

0V DC = error

24V DC = no error

8 Out 1 Light array interrupted

0V DC = interrupted

24V DC = not interrupted

Pin Signal Minimum Maximum

1I Out 4 mA 20 mA

20V DC

3 V Out 0V 10V

40V DC

LED Description Status Meaning

D15 Teach Indicator

Off Teach inactive

Flashing Teach active

Orange Last step of teach process

D16 Analog Output Status

Off V_out = OFF (0V)

Flashing

Start up (ignore output), over

current, or error

Green

Brightness proportional to

analog output

1 2 3 4 5 6 7 8 9 ... 15 16

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 45MLA Controller Installation Instructions Manual de usuario Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 45MLA Controller Installation Instructions