Rockwell-automation 5370-CMPK Color CVIM Module MATH-PAK Manual de usuario descargar pdf (Pagina 58)

Chapter 4

Defining Formulas

4–43

output line, and assign both the High and Low FAULT RANGE limits to

another Results output line.

Formulas prevent the use of associated gage and window outputs: Any

formula you select and enable will disable the use of results outputs from a

corresponding gage or window (as listed in Table 4.A, page 4–3).

Entering Range Limits for Formulas

After you determine the appropriate FAULT RANGE and/or WARNING

RANGE limit values for a formula, you can enter these values using the

range/output setup table.

Define and enable formula first: A formula must be both defined and

enabled before you can enter range limits.

To access the range/output setup table for a formula:

• Pick Range/Outputs on the Config. Results menu to display the

range/output table (see Figure 4.22).

Figure 4.22 Assigning range limits

Calculator pad

Inspection

statistics

table

Range/output

table

If all range limits are currently set to zero as shown in Figure 4.22, enter the

appropriate High and Low FAULT RANGE and/or WARNING RANGE

limits in the following order:

1. Pick the High box under FAULT RANGE. When you do, the calculator

pad appears, as shown in Figure 4.22.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 88 89

Sin comentarios

Rockwell-automation 5370-CMPK Color CVIM Module MATH-PAK Manual de usuario Pagina 58