Rockwell-automation 8510 AC Spindle Drive System Programming Manual Manual de usuario descargar pdf (Pagina 17)

Programming

Chapter 2

2-14

MOTOR SELECT Menu This menu (Figure 2.4) selects the motor that will be used with this drive.

Figure 2.4

MOTOR SELECT Menu Tree

MOTOR SELECT

Catalog Num

This parameter lists the available spindle motors. Simply select the catalog

number of the motor being used. If a motor was previously selected, that

number will be displayed. If a motor was not previously selected, the

display will show “NONE SELECTED.”

Important: The default parameters do not include the motor type. This

parameter must be programmed before attempting to enable the drive or a

fault will occur.

Data Format: 1327AB-AFL-15

Default Value: NONE SELECTED

PARAMETER SET Menu The PARAMETER SET menu allows the selection and programming of

basic drive configuration parameters and preset parameters.

Figure 2.5

PARAMETER SET Menu Tree

PARAMETER SET

ELECT CONFIG

SPINDL PRESET

Acc Rate #1

Acc Rate #2

Low Torq Lmt

At–Set–Speed

Speed Detect

Load Detect

Overspd Trip

ELECT CONFIG

Cmnd Phase #1

Cmnd Phase #2

Motor Phasing

Enable Torque

Drive Cat Num

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 46 47

Sin comentarios

Rockwell-automation 8510 AC Spindle Drive System Programming Manual Manual de usuario Pagina 17