Rockwell-automation FactoryTalk Metrics User Guide Manual de usuario descargar pdf (Pagina 144)

Chapter 4 Automated Configuration

plant model structure that is used in the Report Expert report

templates. Typically, machines that are to be monitored by

FactoryTalk Metrics are defined at the workcell level. The

FactoryTalk Metrics Configuration Tool only configures

plant model entries at the workcell level.

If you want to create the RSBizWare environment from scratch,

refer to the following documents:

• RSBizWare Administration Guide, section "Performing a clean

installation of RSBizWare".

You will find here information on installing and configuring

your RSBizWare environment.

• This document, section "The Plant Model (page 20)".

You will find here information on creating a plant model.

Once you configured your RSBizWare environment, follow these

steps to configure the communication between your ControlLogix

controller and FactoryTalk Metrics:

1. Configure RSLinx Enterprise. (page 144).

2. Import the FactoryTalk Metrics UDT to the ControlLogix

controller (page 148).

3. Create tags based on the FactoryTalk Metrics UDT (page

150).

4. Create FactoryTalk Transaction Manager and FactoryTalk

Metrics configurations (page 154).

TIP

Perform the following steps on the computer on which you have

installed RSLinx Enterprise.

Configure RSLinx Enterprise as an OPC server so that you can use

the FactoryTalk Metrics UDT in ControlLogix controllers to

establish communication with FactoryTalk Metrics. Other OPC

Configuring RSLinx

Enterprise

144 Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 271 272

Sin comentarios

Rockwell-automation FactoryTalk Metrics User Guide Manual de usuario Pagina 144