Rockwell-automation T7470A ICS Regent+Plus Analog Output Modules Manual de usuario

ICS Regent+Plus® PD-7025 Industrial Control Services 1 Analog Output Modules 4 to 20 mA (T7470A) Issue 1, March, 06 Analog output modules provide 4

Analog Output Modules (T7470A) 10 Industrial Control Services Programming Outputs are controlled by writing application programs that solve for ou

Analog Output Modules (T7470A) PD-7025 Mar-06 11 control logic, you maintain the full resolution of the analog output (1 part in 4096) and have a

Analog Output Modules (T7470A) 12 Industrial Control Services Figure 8). During the calibration steps you will remove the printed circuit board f

Analog Output Modules (T7470A) PD-7025 Mar-06 13 precision load resistors to the analog outputs. Figure 9 shows the jumper posts to which you sh

Analog Output Modules (T7470A) 14 Industrial Control Services 2. Install the I/O extender module into the slot from which the module was removed.

Analog Output Modules (T7470A) PD-7025 Mar-06 15 analog output module to the factory for repair or replacement. 14. Calibration is complete. Unp

Analog Output Modules (T7470A) 16 Industrial Control Services Heat Dissipation 10 Watts, 33 BTUs/hour Operating Temperature 0° to 60° C (32° to 14

Analog Output Modules (T7470A) 2 Industrial Control Services module from affecting module operation). The voted result is then passed to the I/O

Analog Output Modules (T7470A) PD-7025 Mar-06 3 to return the correct majority-voted result to the processors produces an I/O module error indic

Analog Output Modules (T7470A) 4 Industrial Control Services Figure 2. Analog Output Module.

Analog Output Modules (T7470A) PD-7025 Mar-06 5 Shutdown Indicator Upon loss of communications with the controller, output modules enter either

Analog Output Modules (T7470A) 6 Industrial Control Services For high integrity applications requiring fail-safe or fault tolerant analog outputs

Analog Output Modules (T7470A) PD-7025 Mar-06 7 Figure 4. Installing Slot Keys. Configuration Each output module is configured using the WIN

Analog Output Modules (T7470A) 8 Industrial Control Services 1) Set the Module Type: Position the cursor on the module slot you wish to define.

Analog Output Modules (T7470A) PD-7025 Mar-06 9 Figure 6. Defining an Analog Output Point. Name Also called the tag name, this is the name use