
Publication 1734-UM003B-EN-P - August 2005
Configure Your Module 4-9
Check I/O Status and View
the EDS File
Use this procedure to complete the entries on the dialogs you display
by clicking the appropriate tab for I/O Defaults and EDS File.
1. From the Counter Module screen, click I/O Defaults from the
top of the dialog, completing the entries shown in the figure.
Click the I/O Defaults tab to display
the default characteristics for this
module.
This dialog shows the input/output
defaults for the four modes. These
are:
Strobe
Polled
Change of state and
Cyclic
Comentarios a estos manuales