Rockwell-automation 1756-ENET/B ControlLogix EtherNet Comm. Interface Manual de usuario descargar pdf (Pagina 14)

14 ControlLogix Ethernet Communication Interface Module

Publication

1756-IN053D-EN-P - June 2002

Troubleshooting the Module

This table describes module health (OK) indicator displays, module

status, and recommended action:

This table describes the transmit (TXD) and receive (RXD) indicator

display:

Where to Find Information on Configuring the Ethernet Module

Now that you have installed your Ethernet module, you must

configure it with an IP Address, Subnet Mask, and Gateway Address.

Refer to the configuration chapter of your ControlLogix Ethernet

Communication Interface Module User Manual, publication

1756-UM051.

If the OK indicator is then module status is take this action

Off Not operating. Apply chassis power.

Verify module is completely inserted

into chassis and backplane.

Red, then flashing red

or flashing green

Performing powerup

diagnostics.

None, normal operation.

Green Operating. None.

Red flashing Not configured.

Configure module (refer to the

configuration chapter of your ControlLogix

Ethernet Communication Interface Module

User Manual, publication 1756-UM051)

Red Unrecoverable fault. Repair or replace module.

If this indicator is the module is

TXD Green Transmitting data

Off Not active

RXD Green Receiving data

Off Not active

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Rockwell-automation 1756-ENET/B ControlLogix EtherNet Comm. Interface Manual de usuario Pagina 14