
Publication 1769-UM008A-EN-P - November 2001
3-18 Installation and Wiring
Terminal Door Label
A removable, write-on label is provided with the module. Remove the
label from the door, mark the identification of each terminal with
permanent ink, and slide the label back into the door. Your markings
(ID tag) will be visible when the module door is closed.
Wiring Diagram Showing Differential Inputs
V in 0 +
V in 1 +
V/I in 0 -
V/I in 1 -
I in 0 +
I in 1 +
V in 2 +
V in 3 +
V/I in 2 -
V/I in 3 -
I in 2 +
I in 3 +
ANLG Com
ANLG Com
V out 0 +
V out 1 +
I out 1 +
I out 0 +
1769-IF4XOF2
V/I in 0 -
ANLG
Com
I out 0 +
I in 0 +
V in 2 +
V/I in 2 -
I in 2+
V out 0 +
V in 0 +
V/I in 1 -
ANLG
Com
I out 1 +
I in 1 +
V in 3 +
V/I in 3 -
I in 3 +
V out 1 +
V in 1 +
Ensure Adjacent Bus Lever is
Unlatched/Latched Before/After
Removing/Inserting Module
DANGER
Do Not Remove RTB Under Power
Unless Area is Non-Hazardous.
+
–
V in 1+
V in 3+
V in 0+
V/I in 0-
I in 1+
I in 3+
V/I in 1 -
I in 0+
I in 2+
V in 2 +
V/I in 3 -
V/I in 2-
ANLG Com
ANLG Com
V out 1+
I out 1+
V out 0+
I out 0+
Belden 8761 cable (or equivalent)
differential voltage
transmitter
1769-IF4XOF2 Terminal Block
earth ground the shield
locally at
the module
(1) All analog commons (ANLG Com) are internally connected.
(2) If multiple power supplies are used, the commons must have the same ground reference.
(3) User Belden 8761 cable (or equivalent) for wiring analog I/O.
Comentarios a estos manuales