
2–13Installing the Input Module
6#-*$"5*0/ ; $"3:
When using shielded cable wire, ground the foil shield and drain
wire only at one end of the cable. We recommend that you wrap the
foil shield and drain wire together, and connect them to a chassis
mounting bolt, grounding stud or chassis single-point grounding
point (Figure 2.5). Use heat shrink tubing to seal the exit point of the
wires. At the opposite end of the cable, tape exposed shield and drain
wire with electrical tape to insulate it from electrical contact.
Figure 2.5
Cable Grounding
&.07& " -&/(5) 0' $"#-&
+"$,&5 '30. 5)& &-%&/
$"#-&
6-- 5)& '0*- 4)*&-% "/% #"3&
%3"*/ 8*3& '30. 5)& */46-"5&%
8*3&4
"3& %3"*/
8*3&
/46-"5&%
8*3&4
0*-
4)*&-%
8*45 5)& '0*- 4)*&-% "/% %3"*/
8*3& 50(&5)&3 50 '03. " 4*/(-&
453"/%
55"$) " (306/% -6( "/% "11-:
)&"5 4)3*/, 56#*/( 50 5)& &9*5 "3&"
&-%&/ "#-&
&/(5) "4 /&&%&%
!)&/ :06 $0//&$5 (306/%*/( $0/%6$5034 50 5)& $)"44*4
(306/%*/( 456% 1-"$& " 45"3 8"4)&3 6/%&3 5)& '*345 -6( 5)&/
1-"$& " /65 8*5) $"15*7& -0$, 8"4)&3 0/ 501 0' &"$) (306/% -6(
306/%*/( 56%
4& 5)& $61 8"4)&3 *' $3*.1;0/ -6(4 "3& /05 64&%
)"44*4 306/%
306/% 6(
306/% 6(
5"3
!"4)&3
)"44*4
*%& -"5&
65 "/% "15*7&
!"4)&3
95&3/"-;5005)
!"4)&34
)3&"%;'03.*/( 4$3&8
)*&-% "/% 3"*/
58*45&% 50(&5)&3
)*&-% "/% 3"*/
58*45&% 50(&5)&3
SingleĆpoint Grounding
95&/% 4)*&-% 50 5&3.*/"5*0/ 10*/5
9104& +645 &/06() $"#-& 50 "%&26"5&-:
5&3.*/"5& *//&3 $0/%6$5034
4& )&"5 4)3*/, 56#*/( 03
05)&3 46*5"#-& */46-"5*0/
8)&3& 8*3& &9*54 $"#-&
+"$,&5
65
&'&3 50 !*3*/( "/% 306/%*/( 6*%&-*/&4 16#-*$"5*0/ ; '03 "%%*5*0/"-
*/'03."5*0/
Grounding
Comentarios a estos manuales