Rockwell-automation 1784-KT2/C INST.DATA COMM.INTERFACE MOD. Manual de usuario descargar pdf (Pagina 16)

Communication Interface Module

Cat. No. 1784-KT2/C

Installation Data

2. When the prompt appears, type the following to select the hard disk:

[ENTER]

3. When the prompt appears, type the following to select the top

directory of the hard disk:

c:\ [ENTER]

4. When the prompt appears, type the following to create a directory

called KT:

mkdir

kt [ENTER)

5. When the prompt appears, type the following to create a directory

called KT2DIAG:

mkdir

kt2diag [ENTER]

6. When the prompt appears, insert the backup copy of the Options and

Diagnostics diskette into drive A:.

7. Type the following to copy the Z80 diagnostic files to the KT

directory:

copy

a:\kt\*.* c:\kt [ENTER]

8. When the prompt appears, type the following to copy the diagnostic

program files to the KT2 directory:

copy

a:\*.* c:\kt2diag [ENTER]

The diagnostic program now resides in the C:\KT2DIAG directory, and the

files the diagnostic program depends on now reside in the C:\KT directory.

Starting up the Diagnostic Program

Read the following checklist to help avoid damage to your network before

starting up the diagnostic program:

Make sure your network or PLC is not connected to a 1784–KT2 while

the diagnostic program is running.

Make sure other programs are not running at the same time the

diagnostic program is running.

Do not run the diagnostic program in a windowing or multi–tasking

environment. The diagnostic program does not support these

environments.

Make sure there are no terminate–stay–resident (TSR) software

programs loaded in your PS/2 before you run the diagnostic program.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Sin comentarios

Rockwell-automation 1784-KT2/C INST.DATA COMM.INTERFACE MOD. Manual de usuario Pagina 16