Rockwell-automation 1785-Lx0C15 ControlNet PLC-5 Programmable Controll Manual de usuario descargar pdf (Pagina 22)

Publication 1785-QS006C-EN-P - April 2002

3-2 Set Up the Software

Start the Programming

Software

Start the programming software by following the procedures

described in your programming software documentation.

If you have difficulty, verify that the power supply is turned on.

Power Up the System Power up the system if you have not done so already. Check the LED

display on the processor. If your system is operating properly, the

PROC LED should be steady red and the message

“Processor RAM

is faulted. Press <Enter> to clear memory” should appear on

the programming software display. See the following table to

proceed. If the PROC LED is not red, turn to chapter 4 for

troubleshooting information.

To monitor your system as you configure and run it, check the

processor LED display for the following indicators:

If your keyswitch

is in this position:

do this:

PROGRAM Clear memory. The PROC LED should turn off.

The software is in Program mode.

REMOTE Clear memory. The PROC LED should turn off.

The software is in Remote Program mode.

RUN You see the message “No access or

privilege violation” because you cannot

clear memory in Run mode. Change the keyswitch

position to Program or Remote and press <Enter> to

clear memory.

This LED: lights when:

COMM you establish serial communication (CH 0)

BATT no battery is installed or the battery voltage is low

REM I/O you establish Remote I/O communication

ADAPT the processor is in adapter mode

FORCE forces are present in your ladder program

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Sin comentarios

Rockwell-automation 1785-Lx0C15 ControlNet PLC-5 Programmable Controll Manual de usuario Pagina 22