Rockwell-automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device Manual de usuario descargar pdf (Pagina 10)

10 Ethernet-to-DeviceNet Linking Device

Rockwell Automation Publication 1788-IN055C-EN-P - September 2011

Connect the Linking Device to the DeviceNet Network

1. Make sure a computer running RSNetWorx for DeviceNet software is

connected to the EtherNet/IP network.

2. With power to the linking device off, connect the DeviceNet network

cable to the DeviceNet connector on the linking device.

The female terminal block connector is provided with the linking

device.

3. Connect the power cable to the linking device.

The female terminal block connector is provided with the linking

device.

ATTENTION:

Do not wire more than 2 conductors on any single terminal.

To comply with the CE Low Voltage Directive (LVD), this equipment must be

powered from a source compliant with Safety Extra Low Voltage (SELV) or

Protected Extra Low Voltage (PELV).

To comply with UL restrictions, this equipment must be powered from a source

compliant with Class 2 or Limited Voltage/Current.

(Red) Net Power 24V DC

(White) CAN High +

CAN Shield

(Blue) CAN Low

(Black) Net Power 24V DC Common

31442-M

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Sin comentarios

Rockwell-automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device Manual de usuario Pagina 10