Rockwell-automation 1788-EN2DNR EtherNet/IP to DeviceNet Linking Devic Manual de usuario descargar pdf (Pagina 12)

12 Rockwell Automation Publication 1788-UM059A-EN-P - August 2014

Chapter 2 Install the Linking Device

Set the DeviceNet Node Address and Data Rate by Using RSNetWorx

for DeviceNet Software

See Set the DeviceNet Node Address and Data Rate on page 20 for information

about using RSNetWorx software to set node address and data rate.

Set the Linking Device

IP Address

Four methods can be used to set the linking device IP address:

• Use the IP address rotary switches on the side of the linking device

• Use the DHCP protocol

• Use RSLinx Software

• Use the web pages of the linking device

Set the Linking Device IP Address by Using the Rotary Switches

The rotary switches are on the right side of the linking device.

Set the IP address according to the table below.

1 250 kbps

2 500 kbps

Other value Data rate selected via RSNetWorx

software

Switch Data Rate

Switch IP Address

000 Administrative mode

The linking device uses the IP address that was used last startup

The web pages are available

001 - 254 192.168.1.XYZ where XYZ is the value of the three switches

888 Reset the linking device to initial out-of-box settings

Other value The linking device starts in operating mode, using the latest configured IP

address

x100

x10

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Sin comentarios

Rockwell-automation 1788-EN2DNR EtherNet/IP to DeviceNet Linking Devic Manual de usuario Pagina 12