Rockwell-automation 1792D-16VT0LP INSTL INSTR ARMORBLOCK INPUT Manual de usuario descargar pdf (Pagina 5)

ArmorBlock LP2 16 Sourcing Input Module 5

Publication 1792D-5.28 - January 1999

Communicate With Your ArmorBlock LP2 Module

This ArmorBlock module’s I/O is exchanged with the master through a

polled, change of state, or cyclic connection.

The module produces input data as follows:

Cyclic - allows configuration of the block as an I/O client. The block will

produce its I/O cyclically at the rate configured.

Polled - a master initiates communication by sending its polled I/O

message to the module. The 16 input module scans the inputs producing a

response that reflects their status.

Change of state - productions occur when an input changes. If no input

change occurs within the expected packet rate, a heartbeat production

occurs. This heartbeat production tells the scanner module that the module

is alive and ready to communicate.

Refer to the table below for the word/bit definitions.

The DeviceNet Network uses advanced network technology, producer/

consumer communication, to increase network functionality and

throughput. Visit our website at http://www.ab.com/networks for producer/

consumer technology information and updates.

Type of I/O Connections Consumes Produces

Cyclic 0 Byte 2 Bytes

Polled 0 Byte 2 Bytes

Change of State 0 Byte 2 Bytes

Bit 0706050403020100

Produces 0

I7 I6 I5 I4 I3 I2 I1 I0

Produces 1

I15 I14 I13 I12 I11 I10 I9 I8

Where:OW = Off Wire I = Input

Byte Bit Description

Produces 0

00-07 Input status bits: When the bit is set (1), the input is on. Bit

00 = input 0, bit 01= input 1, bit 02 = input 2, bit 03 =

input 3, bit 04 = input 4, bit 05 = input 5, bit 06 = input 6,

bit 07 = input 7

Produces 1

00-07 Input status bits: Bit 00 = input 8, bit 01= input 9, bit 02 =

input 10, bit 03 = input 11, bit 04 = input 12, bit 05 = input

13, bit 06 = input 14, bit 07 = input 15

1 2 3 4 5 6 7 8

Sin comentarios

Rockwell-automation 1792D-16VT0LP INSTL INSTR ARMORBLOCK INPUT Manual de usuario Pagina 5