Rockwell-automation 1799ER-IQ10XOQ10 Dual-Port EtherNet Embedded I/O B Manual de usuario descargar pdf (Pagina 5)

Dual-Port EtherNet Embedded I/O Board with 10 Inputs/ 10 Outputs 5

Publication 1799ER-IN001B-EN-P - May 2013

Optional Hardware

All mating connectors and mounting hardware must be ordered separately. This table

identifies the different connector and hardware options.

Install the Board

To install the board:

• set the network address.

• mount the board (brackets, mounting plate, plastic cover).

• connect the board (Ethernet/IP network, Auxiliary Power, I/O).

•communicate with your board.

•configure the parameters.

More detailed information about each of these steps is in the following procedures.

Set the Network Address

The I/O board ships with the rotary switches set to 999 and DHCP enabled. To change

the network address, you can do one of the following:

• adjust the switches on the front of the board.

• use a Dynamic Host Configuration Protocol (DHCP) server, such as Rockwell

Automation BootP/DHCP.

• retrieve the IP address from nonvolatile memory.

The I/O board reads the switches first to determine if the switches are set to a valid

number. To set the network address:

Option Catalog Number Third-party Supplier & Part Number

2 DIN rail brackets (4 screws) 1799-BRKD N/A

Clear plastic cover (4 stand-offs, 4

screws)

1799-COV20E N/A

Mounting plate (4 screws) 1799-MP20E N/A

2, 12-position, gold-plated I/O

mating connectors

1799-12SPCON Phoenix - FK-MC 0.5/12-ST-2.5AU -

1923432

2-position plug for auxiliary power 1799-AUXCON Phoenix Contact, Part number

MSTB2.5/2-ST-5.08 BK/AU - 1765551)

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sin comentarios

Rockwell-automation 1799ER-IQ10XOQ10 Dual-Port EtherNet Embedded I/O B Manual de usuario Pagina 5