Rockwell-automation 2100M Feeder Circuit Breaker Units Secure Support Manual de usuario descargar pdf (Pagina 11)

Rockwell Automation Publication 2100-IN091A-EN-P - April 2013 11

Feeder Circuit Breaker Units Secure Support Pan and Change Door Latch

3. Install the screw retainer over the threaded end of the screw.

Leave a slight gap between the screw retainer and the inside of the door so

the screw retainer is not tight against the door. This provides easier

alignment of the Door Screw with the latch angle bracket.

4. Clean the front door surface, just below the pan-head screw, by using

window glass cleaner and a clean cloth.

5. Align the door-screw torque label with the door edges.

6. Gently work out air bubbles from under the label if they are present.

7. Ensure that all tools, hardware, and other debris have been removed from

the units and section.

8. Close and secure all open unit doors.

9. Power up the equipment in accordance with CENTERLINE 2100 Low

Voltage Motor Control Centers Installation Instructions, publication

2100-IN012

and as per NFPA 70E, Standards for Electrical Safety

Requirements.

ATTENTION: All covers and doors must be in place before applying power to the

MCC. If units are removed, they must be replaced with the appropriate items,

such as units, doors, and unit support pans.

¼-20 Pan-head Screw

Screw Retainer

1 2 ... 6 7 8 9 10 11 12

Sin comentarios

Rockwell-automation 2100M Feeder Circuit Breaker Units Secure Support Manual de usuario Pagina 11