Rockwell-automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL Manual de usuario descargar pdf (Pagina 37)

Chapter 6

Operating Modes

6–7

The procedure for entering messages into the module is interactive:

Step 1 - Remove power before plugging keyboard into the module.

Step 2 - Depress any key to enter the edit mode.

Step 3 - The module asks you for a message number:

Step 4 - Type a message number (1 to 120) and depress ENTER or depress

ENTER to edit message number displayed.

Step 5 - If the number you entered has a message assigned to it, the module

displays that message for you to edit.

If the number is unassigned, you get a blank display, with the cursor in the

left–most position.

Step 6 - Enter a message by typing the text you want - up to 16 characters.

(See the following page for a list of editing commands.)

Step 7 - Depress ENTER to complete the message and save it in EEPROM.

Step 8 - The module adds one to the message number, then

Step 9 - Depress Control–R any time to end the entry / edit session.

Storing

Messages go into EEPROM as you create them. When you depress ENTER

to complete a message, the Module stores the message automatically. No

special procedures are needed.

Editing

The message editing function is exactly the same as the message entry

function.

When you have a message on the display, any characters you type will

overwrite the characters on the display. Store the message, when you have it

to your liking, by depressing ENTER.

Entering Messages

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 92 93

Sin comentarios

Rockwell-automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL Manual de usuario Pagina 37