Rockwell-automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL Manual de usuario descargar pdf (Pagina 38)

Chapter 6

Operating Modes

6–8

The editing commands are single key strokes:

Left arrow (

←)-Move cursor one position to the left.

Right arrow(

→)-Move cursor one position to the right.

Down arrow(

↓)-Decrement number of message to be created or

edited.

Up arrow(

↑)-Increment number of message to be created or

edited.

Control–B - Set message FLASH attribute.

Control–D - Delete message and return to run mode.

Control–F - Display number of free messages.

Control–R - End edit and save current message, then go to RUN

mode.

Control–S - Select message number.

ENTER - Save message being edited, and move on to the next

message.

ESC - Cancel current edit and return to run mode.

Control–E - Correct “EEPROM CRC ERROR” and return to run

mode.

Control–I - Initialize messages and return to run mode.

Note –Messages may also be entered/stored on floppy disk and downloaded

using a IBM PC or compatible with the Keypad Programming Software

(Catalog Number 2705–ND1). Refer to the Software User’s Manual

(Catalog Number 2705–ND003) for additional information.

Editing Commands

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 92 93

Sin comentarios

Rockwell-automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL Manual de usuario Pagina 38