Rockwell-automation 2706-NP5 DL5 OFFLINE PROGRAMMER USER MANUAL Manual de usuario descargar pdf (Pagina 9)

Chapter 2

Installing the Software

2–3

Note: This installation procedure is for an IBM AT. Your computer will use

the same or similar prompts and responses.

Important: The recommended way of using Off-line Programmer on a

computer with a single floppy or micro disk is to create a storage disk for

your DL5 files. Storing files on the DL5 off-line programming disk

restricts the number of files you can create.

ATTENTION: Before you begin this procedure, ”write protect”

your DOS disk by using a write protect tab. See your computer

user manual.

1. Insert your computer’s “write protected” DOS disk into the disk drive and

turn on the computer.

2. When the DOS prompt (A: \ >) is displayed, remove the DOS disk and

insert the DL5 off-line programming disk.

3. Type:

DL5 [ENTER]

The Off-line Programmer will begin.

4. Before you begin programming, remove the DL5 off-line programming

disk and insert a formatted storage disk.

stems

Flopp

or Micro Disk Drive

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Sin comentarios

Rockwell-automation 2706-NP5 DL5 OFFLINE PROGRAMMER USER MANUAL Manual de usuario Pagina 9