Rockwell-automation 280D ArmorStart - Getting Started Manual de usuario descargar pdf (Pagina 16)

Publication 280D-QS001D-EN-P - July 2006

required, the information below can be used to map a device based on the

default configuration.

Table 3 Default I/O Messaging Data

Default Input and Output (I/O) Assembly Formats

The I/O assembly formats for the ArmorStart

are identified by the value in

parameter 11 (Consumed IO Assy.) and parameter 12 (Produced IO Assy.).

These values determine the amount and arrangement of the information

communicated to the master scanner. The tables below identify the default

information produced and consumed by DOL (Bulletin 280) and Reversing

(Bulletin 281) devices. For additional formats and advance configurations

please reference the user manual:

Defaults for Standard Distributed Motor Controllers

Table 4 Instance 160 - Default Consumed data for Standard Distributed Motor

Controller Output information arrangement (1 byte)

Table 5 Instance 161 - Default Produced data for Standard Distributed Motor

Controller Input information arrangement (2 bytes)

Setting the Motor FLA and Overload Trip Class

The product should now be configured and communicating on the network.

The last step is to program the proper motor FLA setting (parameter #106)

and overload trip class (parameter #107). This can be accomplished by

using software such as RSNetWorx for DeviceNet or a handheld DeviceNet

tool.

Default

Message type Polled

Consumed data size 1 byte (Rx)

Produced data size 2 bytes (Tx)

Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0

User Out

Not

Used

Not

Used

Not

Used

Fault

Reset

Run Rev Run Fwd

Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0

Not

Used

Not

Used

Not

Used

Ready

Running

Rev

Running

Fwd

Warning Tripped

Not

Used

Not

Used

140M

HOA

Status

User In 3 User In 2 User In 1 User In 0

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 280D ArmorStart - Getting Started Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 280D ArmorStart - Getting Started