Rockwell-automation 4100 ESRS Encoder Signal Reference Simulator Insta Manual de usuario descargar pdf (Pagina 33)

Publication 4100-IN505A-EN-P - October 2000

Operation 3-7

Setting the Option Switch

You must remove the side panel of the ESRS box to gain access to the

DIP switches.

Set the DIP switches by pressing the appropriate lever to either its ON

or OFF position based on the following switch setting values.

When configuring the ESRS with the DIP switches, some of the

settings are cumulative. These setting combinations determine the

actual configuration. Make sure all of the levers are in the correct

position for the desired configuration.

Mode Selection

DIP switch levers 1 and 2 determine the operating mode of the ESRS.

Switch 1 – ON = Unidirectional; OFF = Bi-directional.

Switch 2 – ON = Unidirectional Mode - Forward;

OFF = Unidirectional Mode - Reverse.

ATTENTION

Removal of the side panel and setting of DIP

switches should be performed by authorized

personnel only. Proper safety precautions must be

followed to reduce the risk of damage to the unit,

other equipment, and health of personnel.

TIP

When Switch 1 is in the OFF position, for

Bi-directional Mode, Switch 2 has no effect.

1 2 ... 28 29 30 31 32 33 34 35 36 37

Sin comentarios

Rockwell-automation 4100 ESRS Encoder Signal Reference Simulator Insta Manual de usuario Pagina 33