Rockwell-automation 57RF RFID ICODE Handheld Interface User Manual Manual de usuario descargar pdf (Pagina 18)

18 Rockwell Automation Publication 57RF-UM001A-EN-P - September 2011

Chapter 3

Rear Components

This section describes the components found on the rear of the RFID ICODE

handheld interface.

Figure 14 - Rear Components

Compact Flash Slot Cover

The compact flash slot cover located on the top of the unit provides access to the

compact flash slot that stores memory and device cards. The hatch cover

thoroughly seals the RFID ICODE handheld interface to maintain a total IP65

solution. Four screws secure the cover to the top of the RFID ICODE handheld

interface. To insert device or memory cards into the compact flash slot, you must

first remove these screws using a flat head screwdriver.

For more information about inserting and removing memory and device cards,

see “Using the Compact Flash Slot

” on page 27.

Figure 15 - Compact Flash Slot Hatch

Table 6 - Rear Components

Item Function Description

1 RFID Module The RFID Module attached to the rear of the unit can read RFID tags in

its storage position (shown above) or swing out up to 180° for

maximum range. See the RFID Read Range figure on page 27.

2 Battery

Compartment

The battery compartment can store either the Nickel Metal Hydride

(NiMH) rechargeable battery pack or six AA alkaline batteries. You can

access the battery compartment by lifting up and turning the retaining

clip.

For more information using batteries, see “Replacing Batteries/Battery

Pack on page 24.”

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 111 112

Sin comentarios

Rockwell-automation 57RF RFID ICODE Handheld Interface User Manual Manual de usuario Pagina 18