Rockwell-automation 61C350 2-In/2-Out 0-10 Volt Analog Rail Module Manual de usuario descargar pdf (Pagina 14)

2Ć4

DAC

IĆOUT

RFB

+15V

+VĆOUT

-VĆCOMMON

10K

Figure 2.2 Ć Typical Output Circuit

 to A/D

converter

VĆIN

VĆOUT

90K

Figure 2.3 Ć Typical Input Circuit

The Analog Rail module is factory calibrated and requires no

offset/gain adjustment. All four analog I/O channels are referenced

to the same common. This common is isolated from both the

external power supply and the I/O port connection.

The module incorporates extensive diagnostics. In Rail mode, check

bits are monitored for accuracy on every transfer of data between

the host and the module. In Local Head mode, parity bits are

monitored for accuracy on every transfer of data. A Rail fault LED on

the processor, Remote Head, or Local Head will be illuminated if the

check bits or parity bits are wrong and all transmission will stop after

n retries, where n is a value determined by the host's software

(averagen=4forAutoMax; AutoMaten=2).

In the event of a rail fault, all outputs will be set to 0. The COM OK"

LED on the module will go off. If any power required by the module,

i.e., the +5 Volts from the I/O port required for communication, the

external power supply, or the power required by the Analog I/O

section, is not within specified limits, all outputs will be set to 0 and

the PWR OK" LED will go off.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Sin comentarios

Rockwell-automation 61C350 2-In/2-Out 0-10 Volt Analog Rail Module Manual de usuario Pagina 14