Rockwell-automation FactoryTalk Historian SE 4.0 Live Data Interface U Manual de usuario descargar pdf (Pagina 51)

Rockwell Automation Publication HSELD-UM024A-EN-E–September 2013 51

Chapter 12

Error and Informational Messages

The FTLD Interface is based on the PI-UniInt framework,

therefore a few error messages are sent to the PIPC log by PI-UniInt.

Other error messages are sent to the FactoryTalk Diagnostics

system. When troubleshooting, we recommend that you check both

FactoryTalk Diagnostics and the PIPC log.

The following is the list of error messages sent to FactoryTalk

Diagnostics.

Severity Message text

Error Failed to disconnect from FactoryTalk.

Error Failed to initialize COM library.

Error Failed to initialize COM security.

Error Missing or invalid interface ID parameter.

Error Failed to initialize FactoryTalk Diagnostics.

Error Failed to launch FTLD interface due to the lack of the parameter

/FTDirectory.

Error Failed to launch FTLD interface due to the lack of the parameter

/FTContext.

Error Failed to connect to FactoryTalk Directory scope %s.

Error System error: Insufficient memory.

Warning Failed to remove FactoryTalk Live Data item <%s>.

Warning PI point <%s> is refused because of failure to add FactoryTalk Live

Data item <%s>.

Warning PI point <%s> is refused because of the invalid attribute of

Location [3].

Warning PI point <%s> is refused because of the invalid attribute of

InstrumentTag.

Warning PI point <%s> is refused because of the invalid attribute of

Location [4].

Warning The value quality of PI point <%s (PointID: %d)> with FactoryTalk

Live Data item <%s> is bad.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 57 58

Sin comentarios

Rockwell-automation FactoryTalk Historian SE 4.0 Live Data Interface U Manual de usuario Pagina 51