Rockwell-automation 1336S Language Module Installation/Replacement Manual de usuario descargar pdf

Instructions

This publication will guide you through installation (or replacement)

of the 1336 PLUS Language Module.

1. Check the version of ﬁrmware presently installed in the drive.

If the current version is 1.04 or greater, proceed to step 2.

If you have version 1.03, parameters 111-127 and 180 must be

checked. The value of each parameter

must be greater than zero

and less than 212. If any value is outside of this range, reprogram

using the Program mode before proceeding to step 2.

Important:

Ifparameters127and/or180aresetto“0”(zero),these

must be reprogrammed to “1.”

If the above is not performed, an "EE Init Read" fault (F53) will

be issued when the drive is powered up with the new Language

Module.

2. Remove and lock-out all incoming power to the drive. Remove

the drive cover.

ATTENTION: This drive contains ESD (Electrostatic

Discharge) sensitive parts and assemblies. Static control

precautions are required when installing, testing, servicing

or repairing this assembly. Component damage may result

if ESD control procedures are not followed. If you are not

familiar with static control procedures, reference A-B

publication 8000-4.5.2, “Guarding Against Electrostatic

Damage” or any other applicable ESD protection

handbook.

ATTENTION: To avoid a shock hazard, assure that all

powertothedrivehasbeenremovedbeforeproceedingwith

the following procedure. In addition, verify that the DC bus

has discharged by measuringacross the“+ DC”and “– DC”

terminals of TB1 with a voltmeter. The voltage should be

0.0V DC.

1336 PLUS Language Module

Installation/Replacement

1 2 3 4

Indice de contenidos

Pagina 1 - Installation/Replacement

InstructionsThis publication will guide you through installation (or replacement)of the 1336 PLUS Language Module.1. Check the version of ﬁrmware pres

Pagina 2 - Frames A1 - A4 Frames B - G

2 1336 PLUS Language Module Installation/Replacement3. Using the ﬁgure above, locate the LanguageModule for your drive and note orientation.On 0.37-3.

Pagina 3

1336 PLUS Language Module Installation/Replacement 34. Remove the module by squeezing the sides-in, and pulling outward. Discard module.5. Position th

Pagina 4

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 1336S Language Module Installation/Replacement Manual de usuario

Busca en linea o descarga Manual de usuario para Equipo Rockwell-automation 1336S Language Module Installation/Replacement. Rockwell Automation 1336S Language Module Installation/Replacement User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 1336S Language Module Installation/Replacement