Rockwell-automation 1394-DIM Installing Your Drive Interface Module Manual de usuario descargar pdf (Pagina 12)

12 Installing Your 1394 Drive Interface Module

5. Strip the wire insulation back on the cable lead.

ortant:

Use 14-20 gauge wire to ensure proper system

operation.

6. Trim the cable lead to expose 7.0 mm (0.275 in.) of metal wire.

7. Insert the cable lead in the appropriate terminal.

Figure 18

Cable Connector

8. Use a screwdriver to tighten the clamping screw to the correct

torque (0.25 N-m/2.2 lb-in.) until the cable lead cannot be pulled

out of the terminal.

9. Using the table below, complete the termination connections.

10. Connect each external drive to the 1394-DIM.

ortant:

Connect all DIM axes in succession (from the front

of the unit to the back of the unit) starting with DIM

Axis A regardless of the number of servo axis

modules in the 1394 system.

Insert cable wires into the

connector openings here

If the cable lead: Do this:

Pulls out of the terminal Go to step 4.

Does not pull out of the

terminal

1. Move to the next terminal

and go to step 2.

2. When all seven terminals

are wired, go to step 10.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Rockwell-automation 1394-DIM Installing Your Drive Interface Module Manual de usuario Pagina 12