Rockwell-automation 1394-DIM Installing Your Drive Interface Module Manual de usuario descargar pdf (Pagina 5)

Installing Your 1394 Drive Interface Module 5

5. Attach the terminator to the 1394-DIM and slide it to the left until

it locks into place, as shown in the figure below.

Figure 7

Attaching the Terminator

6. Install the lower fastener.

7. Tighten the upper and lower fasteners.

1394-DIM Configurations

The identity and number of the axes you can connect to a 1394-DIM

depends upon the number of 1394 axis modules connected to your

1394 system in addition to the 1394-DIM.

The figure below shows the input connections located on the bottom

of a typical 1394 system and a 1394-DIM.

Figure 8

A 1394-DIM Connected to a GMC or GMC Turbo

A 1394x-SJTxx-C, -C-RL, -T, and -T-RL system module can control a

maximum of four physical axes. The 1394C-SJTxx-L and -L-RL can

control only one axis. Each 1394 axis module added to the 1394

system reduces the number of external drives and axes the 1394-DIM

can control by one.

Attaching the

Terminator

Rear of the units

Front of the units

Bottom of the

1394-DIM

Bottom of the

1394 GMC or 1394

GMC Turbo System

1394-DIM ground connector

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sin comentarios

Rockwell-automation 1394-DIM Installing Your Drive Interface Module Manual de usuario Pagina 5