Rockwell-automation 1608P-200A480V... HC-DySC User Manual Manual de usuario descargar pdf (Pagina 35)

35 Rockwell Automation Publication 1608P-UM005A-EN-P - November 2014

Chapter 6 Maintenance

COM_VER

Start-Up Test: Communication

Compatibility Mismatch

Call Service Unit

Firmware communication compatibility problem detected during start-up

test.

Call service.

CNFG_TO

Start-Up Test: Controller

Configuration Timeout

Call Service Unit Controller communication problem detected during start-up test. Call service.

CNFG_ERR

Start-Up Test: Controller

Configuration Mismatch

Call Service Unit Controller firmware configuration problem detected during start-up test. Call service.

FIRM_TO

Start-Up Test: Controller Firmware

Check Timeout

Call Service Unit Controller communication problem detected during start-up test. Call service.

FIRM_DIFF

Start-Up Test: Controller Firmware

Revision Mismatch

Call Service Unit Controller firmware revision mismatch detected during start-up test. Call service.

SRL_TO

Start-Up Test: Controller Serial

Number Check Timeout

Call Service Unit Controller communication problem detected during start-up test. Call service.

SRL_DIFF

Start-Up Test: Serial Number

Mismatch

Informational Unit Controller serial number mismatch detected during start-up test. No action needed.

T_INV_TO Inverter Test Timeout Call Service Unit Phase control board failed to respond to Comm board's Inverter test. Call service.

47 CRIT_OT Critical Over-Temperature Manual Reset Unit

Internal DySC temperature exceeded maximum rating. Mechanical bypass

commanded.

Verify ambient temperature is within DySC specification.

Check for damaged fans. Check for dirty or obstructed air filters.

Manually reset DySC.

48 FUSE_OPEN Fuse Open Call Service Unit One of the DySC fuses was detected open. Mechanical bypass commanded. Call service.

49 OPEN_SCR_A Open SCR Phase A Call Service Static Switch The SCR on the phase A module was detected open. Call service.

50 OPEN_SCR_B Open SCR Phase B Call Service Static Switch The SCR on the phase B module was detected open. Call service.

51 OPEN_SCR_C Open SCR Phase C Call Service Static Switch The SCR on the phase C module was detected open. Call service.

53 DYN_BRAKE Dynamic Brake Error Call Service Unit A problem was detected with the DySC dynamic brake controller. Call service.

58 PLC_ERR

Programmable Logic Controller

Error

Call Service PLC PLC error detected. Call service.

59 PLC_ST_MM

Programmable Logic Controller

State Mismatch

Call Service Unit PLC feedback error detected. Call service.

73 INPUT_PS_FAIL Input Control Power Supply Failure Call Service Unit System output control power supply is not operating properly. Call service.

74 OUTPUT_PS_FAIL

Output Control Power Supply

Failure

Call Service Unit System output control power supply is not operating properly. Call service.

Event

Code Code Name Full Name Severity Area Event Description Event Resolution

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 44 45

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 1608P-200A480V... HC-DySC User Manual Manual de usuario Pagina 35

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 1608P-200A480V... HC-DySC User Manual