Rockwell-automation 1738-AENT, Series B ArmorPOINT I/O EtherNet/IP Ada Manual de usuario descargar pdf (Pagina 6)

6 1738 ArmorPOINT I/O EtherNet/IP Adapter

Publication 1738-IN031A-EN-P - July 2013

Before You Begin

To effectively use your adapter, note the following considerations.

Determine Compatibility

If using the adapter with a 1756-ENBT module or 1788-ENBT module, use the following

required firmware versions for these bridge modules:

• 1756-ENBT firmware version 2.3 or greater

• 1788-ENBT firmware version 1.33 or greater

If you use the BootP Utility to assign IP addresses to the adapter, use version 2.3.2 or

greater.

Understand Messaging

Class 3 (Explicit Message) requests through the 1738-AENT adapter to a specific

ArmorPOINT I/O module do not always receive a response from the module. In the case

where an ArmorPOINT module does not reply to a request, the adapter responds with an

error code indicating a time-out.

Configure Autobaud

The adapter cannot reconfigure an I/O module that you previously configured to operate

at a fixed baud rate. When you reuse an ArmorPOINT I/O module from another

ArmorPOINT I/O system, configure the module to autobaud before using it with the

adapter.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Sin comentarios

Rockwell-automation 1738-AENT, Series B ArmorPOINT I/O EtherNet/IP Ada Manual de usuario Pagina 6