Rockwell-automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTA Manual de usuario descargar pdf (Pagina 32)

4-2 Attaching to a Processor

Publication 1747-6.1

6. To change the node address:

• Scroll through the list of active node addresses attached to the

network. Press [

]or[ ].

• Use the numeric keys to enter a value from 0 through 31.

7. Once the appropriate node address is displayed:

Press [

8. The module displays the Ready Attached screen:

If the processor you are attaching to is password-protected, refer to

the section on attaching to a password-protected processor on

page 4-4.

Auto Attach Procedure

If the module is configured with the Auto Attach feature set to On:

1. At power up, the module displays:

2. When the module completes the attach procedure, the display

shows the Ready Attached screen:

If the module has not been previously attached to a processor or if the

last processor it was attached to is no longer active, the display shows:

1. To change the node address:

•Press[

]or[ ] to scroll through the list of active node

addresses attached to the network.

• Use the numeric keys to enter a value from 0 through 31.

2. Once the appropriate node address is displayed:

Press [

If the processor you are attaching to is password-protected, refer to

the section on attaching to a password-protected processor on

page 4-4.

RDY> 4 RRUN

5/02 4444

Attach to CPU?

WORKING . . . .

RDY> 4 RRUN

5/02 4444

Attach to CPU?

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 115 116

Sin comentarios

Rockwell-automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTA Manual de usuario Pagina 32