Rockwell-automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTA Manual de usuario descargar pdf (Pagina 34)

4-4 Attaching to a Processor

Publication 1747-6.1

If you press and release the [ ]key,thenpressandreleasethe

[ ] key, the display appears as:

To restore the default value of 15, press and release the

[ ] key,

then press and release the [

]key.

Attachingtoa

Password Protected

Processor

In either of the previous procedures, if the processor you are attaching

to is password-protected. The module displays:

1. Use the numeric keys to enter the password.

2. As the password keys are pressed, the module displays asterisks

in the lower right hand corner.

3. When the password is complete:

Press [

4. When the password is accepted, the Ready Attached screen

displays:

If any variations of the above procedures occur, refer to chapter 9,

Troubleshooting.

5. After successfully attaching to a processor, you can now:

• Change the module setup. Refer to chapter 3, Module Setup

Procedure.

• Clear an existing Quick Recall Function. Refer to chapter 6,

Quick Recall Functions.

• Observe and respond to a displayed message. Refer to chapter 8,

Message Capability.

Attach to CPU?

Enter Password?

Important: During password entry, if you backspace to the

beginning of the password (using [

]),

your password entry is invalid. the following message is

displayed:

RDY>

Function Failed

RDY> 4 RRUN

5/02 4444

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 115 116

Sin comentarios

Rockwell-automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTA Manual de usuario Pagina 34