Rockwell-automation 1756-ENBT ControlLogix EtherNet/IP Bridge Module I Manual de usuario descargar pdf (Pagina 17)

ControlLogix EtherNet/IP Bridge Module 17

Publication

1756-IN019C-EN-P - November 2004

Link Status Indicator

The Link Status LED provides the following information:

OK Status Indicator

The OK Status LED provides the following module information:

Where to Find Information on Configuring the Module

To configure your module, refer to the configuration chapter of your

EtherNet/IP Modules User Manual, publication number ENET-UM001,

available online at www.rockwellautomation.com/literature.

State Status Description

Off No data transmission Module is not ready to communicate.

Green Ready Module is ready to communicate.

Flashing Green Data transmission in

progress

Module is communicating over the

network.

State Status Description

Off No Power Module does not have 24V DC power.

Verify there is chassis power and the

module is completely inserted into

chassis and backplane.

Flashing Green Standby Module is not configured.

Green Operational Module is operating correctly.

Flashing Red Minor Fault A recoverable fault has been detected.

This could be caused by an error in the

configuration.

Red Major Fault An unrecoverable fault has been

detected. Recycle power to the module.

If this does not clear the fault, replace

the module.

Flashing Red and Green Self Test Module performing power-up self-test.

1 2 ... 12 13 14 15 16 17 18 19 20

Sin comentarios

Rockwell-automation 1756-ENBT ControlLogix EtherNet/IP Bridge Module I Manual de usuario Pagina 17