Rockwell-automation 1757-PROCESSLINX ProcessLinx OPC Server to Server Manual de usuario descargar pdf (Pagina 9)

1 Publication 1757-UM002B-EN-P - January 2003

Chapter

Setup Procedures

Installation

This chapter contains an overview of the setup procedure and the steps you

need to take to set up a configuration prior to using ProcessLinx.

Configuring DCS Components

All DCS Components must be configured first in the setup procedure. This

includes installation and setup of the following:

• ProcessLogix System – The ProcessLogix system must be setup and

installed on the PC used to access the ProcessLogix OPC Server.

• DCS – The other DCS system is assumed to be setup prior to

performing the steps in the section Creating a ProcessLinx TagMap

Configuration on page 3-10.

Installing OPC Servers

Install the desired OPC servers. If a remote DCOM connection is required,

verify the PC is setup on the network with the TCP/IP protocol installed. The

OPC Servers are specified below:

ProcessLogix OPC Server

All of the software components of the ProcessLogix OPC Server are installed

during the ProcessLogix Server installation.

IMPORTANT

You are required to configure the DCS components before

installing ProcessLinx. If the DCS components are not

configured correctly, server communications will not

succeed.

IMPORTANT

The OPC Server option MUST be included with your

ProcessLogix license.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 69 70

Sin comentarios

Rockwell-automation 1757-PROCESSLINX ProcessLinx OPC Server to Server Manual de usuario Pagina 9