
2–9Installing Your Module
,$"+"'& ),)/
After setting the adapter module switch assemblies, you must also
• set the I/O chassis backplane switches
Setting the Backplane Switch Assembly
The backplane switch assembly is located on the backplane of the
I/O chassis. You use it to select:
• the last state of all outputs
• the processor restart lockout feature
• 1/2-, 1- or 2-slot addressing
• the last chassis in the I/O system (for PLC-2 family processors)
Refer to the table below for backplane switch setting illustrations for
the various processors.
For Processor: Refer to:
1 " ,) (
1 " ,) (
1 " ,) (
1 )%'+ '&" ,)+"'& " ,) (
1 " ,) (
Figure 2.8
I/O Chassis Backplane Switch Assembly Settings for
Remote Adapter Module in PLCĆ2 Family Processor System
Processor Restart Lockout Ć
!& ()'**') & )*+)+ !**"*
!& !**"* %,*+ )*+)+ + +! !**"*
Addressing Switch Ć
1 1*$'+ )**"& *$+
1 1*$'+ )**"& *$+
Last State Switch Ć
!& ',+(,+* ' +!"* !**"* )%"&
"& $*+ *++
!& ',+(,+* ' +!"* !**"* )
&) "0 .!& ,$+ "* ++
$./*
Last Chassis Switch Ć
1 !**"* '* &'+ '&+"& +! !" !*+ &,%)
)',( ') +! **'"+ )# &,%)
1 !**"* '* '&+"& +! !" !*+ &,%)
)',( ') +! **'"+ )# &,%)
/', !- '&$/ ()"%)/ !**"* *+ +!"*
*."+! +'
/', !- '+! ()"%)/ & '%($%&+)/
!**"* *+ +! ()"%)/ !**"* +' & +!
'%($%&+)/ !**"* +'
ATTENTION: + *."+! +' +! ('*"+"'&
+' &) "0 ',+(,+* .") +' +!"* !**"* .!&
,$+ "* ++ *."+! "* *+ +' +!
('*"+"'& ',+(,+* '&&+ +' +!"* !**"* )%"&
"& +!") $*+ *++ .!& ,$+ ',)* & %!"&
%'+"'& %/ '&+"&, +) ,$+ ++"'&
O
O
12345678
N
F
F
$./*
Setting the I/O Chassis
Switches
Comentarios a estos manuales