Rockwell-automation 1784-KTCS ControlNET Scanner Installation Instruct Manual de usuario descargar pdf (Pagina 21)

ControlNet Scanner Card 21

Publication

1784-5.35 – April 1999

10. Click Next to continue.

The wizard prepares to reset the card, and reports

Card has been r

eset.

LEDs should be alternating green and red. Congratulations, the check wizard

has verified proper configuration of your 1784-KTCS card in your computer.

If the wizard fails, check the I/O base address on the card against the I/O base

address you entered into the wizard. If the check wizard fails and the card I/O

address and wizard address are identical, call Rockwell Automation T

echnical

Support at 440-646-6800 for assistance.

Connecting the Card

After you have installed the card, you can connect it:

• to a device already connected to the ControlNet network via the 1786-CP

network access port cable (page 23)

Important: This is only a temporary connection. As a permanent

connection, the KTCS card should connect via a

ControlNet tap.

• directly to a ControlNet network via a ControlNet tap (page 26)

Figure 3 shows the card connector.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Sin comentarios

Rockwell-automation 1784-KTCS ControlNET Scanner Installation Instruct Manual de usuario Pagina 21