Rockwell-automation 1784-KTCS ControlNET Scanner Installation Instruct Manual de usuario descargar pdf (Pagina 5)

ControlNet Scanner Card 5

Publication

1784-5.35 – April 1999

Configuring the Card Hardware

Before you install the card, you must set the card’

s physical addresses for the:

•

ROM I/O expansion area of the host processor

’

s system

memory—enables the card and the host computer to exchange data through

the dual-port interface. This is the base memory address.

•

host processor

’s I/O map—enables the card’

s I/O devices to receive

commands from the host computer

. This is the

base I/O space addr

ess.

ou can have as many as four KTCS cards in one computer as long as each card

has dif

ferent base memory and base I/O space addresses.

o configure these addresses, you set switches on the card. The card comes

factory-set with these default addresses:

Address Type Address Setting (hex)

base memory D000:0000

base I/O space memory 220

Important: When

deciding which addresses to use, remember that each card

in your computer must have a unique

base memory address and a

unique base I/O space memory address. If another card in the host

computer is using one or both of the factory-set addresses, you

must change a card’

s switch settings to an available address.

If you are: go to:

changing addresses on the card

“Selecting the Base Memory Address

Location” on page 6

using the factory-set addresses “Installing the Card” on page 15

1 2 3 4 5 6 7 8 9 10 ... 31 32

Sin comentarios

Rockwell-automation 1784-KTCS ControlNET Scanner Installation Instruct Manual de usuario Pagina 5